Jjc RM-E7 Manual de usuario descargar pdf

JJC RM-E7 Infrared Remote Control Instruction

Thank you for purchasing JJC RM-E7 Infrared Remote Control, For the best performance,

please read this instruction carefully before use.

z To use RM-E7 Remote Control

1. For the first time use, please pull out the plastic separator (if your remote control

has it) at the battery holder.

2. Mount the camera on a tripod (recommended) or place the camera on a stable,

level surface.

3. Press the button and rotate main command dial until (delayed remote) or (quick

response remote) is displayed in the control panel.

4. Aim the transmitter on the remote control at the infrared receiver on the camera

(usually within +/- 20 degree of the lens axis, from the left to the right and from the

top to the bottom) and press the shutter-release button on the remote control

(when using the remote outdoors, make sure that the subject is not backlit and

that the line of site between the transmitter and the infrared receiver is not blocked

by the lens or other obstacles).

5. How the camera focuses and shoots depends on the option selected for your

camera's custom setting. For further information, check your camera's manual.

6. Infrared cannot be seen by human eyes. So you will see no visible light from the

LED on the front end of the remote control when operating.

z To Replace the Battery

1 2

Pagina 1

1JJC RM-E7 Infrared Remote Control Instruction Thank you for purchasing JJC RM-E7 Infrared Remote Control, For the best performance, please read this

21. The remote control is powered by a three-volt CR2032 lithium battery which is already included in. 2. After sliding the latch in the direction

Sin comentarios

Jjc RM-E7 Manual de usuario